st32

SpraySept14

Household Care Formulary, Continued Suppliers: 1Seppic 2Dow Corning 3Sozio 4Texas Aniline Dye Co., Inc. Procedure: Charge the tank with Part A ingredients and start mixing at low speed to prevent foam. Add Part B ingredients and increase the mixing speed. After a few minutes of mixing, add Part C. Continue to mix with increasing mixing speed to ensure that the batch is moving properly. Maintain high mixing speed until the product turns white. Reduce mixing speed slightly and slowly add Parts C and D. (Note: viscosity will grow thinner as Part D is added.) To avoid incorporating air into the product, reduce mixing speed accordingly. When the batch is homogeneous, stop mixing. Properties: Appearance:..................................................Fluid white emulsion pH:............................................................................................. 5.7 Viscosity:..................................................1,840 cps at room temp. Source: Seppic Trade Name/INCI Designation...........................................%w/w Part A Deionized water.......................................................................94.5 Part B AMMONYX LO Special/(Lauramine Oxide)1......................... 3.0 Part C BIO-SOFT EC-6901................................................................... 1.1 Part D Dowanol PnB/(Propylene Glycol n-Butyl Ether)2..................... 1.0 Enviomet EDDS/(S,S-Ethylenediaminedisuccinic acid)3....... 0.5 Part E Citric Acid 50% aq. solution..................................................q.s. Suppliers: 1Stepan 2Dow 3Innospec Procedure: Charge Part A. Blend in Part B. With good agitation, slowly add Part C. Mix until homogeneous. Add Part D. Adjust pH to 5.0–5.5 with Part E. Properties: Appearance:.................................................................Clear liquid pH:......................................................................................5.0–5.5 Viscosity:........................................................................Water thin Source: Stepan 32 Spray September 2014 Trade Name/INCI Designation...........................................%w/w Part A Water.....................................................................................96.95 Part B NatraSense AG-8101................................................................. 1.00 Benzisothiazolinone.................................................................0.03 Part C CrystaSense Sapphire1.............................................................2.00 Part D Potassium hydroxide (10% solution)............................To pH 11.5 Suppliers: 1Croda Procedure: Add Part B to Part A and mix until homogeneous. Add Part C under stirring to obtain an opaque solution. Adjust to pH 11.5 with Part D to achieve a clear, thickened solution. Low mixing speeds are recommended to reduce the formation of bubbles. Properties: Viscosity: 44,000 cP at 20°C Source: Croda Trade Name/INCI Designation...........................................%w/w Part A Deionized water....................................................................... 91.0 Part B Citric Acid................................................................................. 4.0 Part C AMMONYX LO Special/(Lauramine Oxide)1...................... 2.00 Suppliers: 1Stepan Procedure: Charge Part A. With good agitation, add Part B. Blend in Part C. Mix until homogeneous. Properties: Appearance:.................................................................Clear liquid pH:............................................................................................. 2.7 Viscosity:........................................................................Water thin Source: Stepan Daily Shower Cleaner (Formula #1125) General Degreaser Thickened with CrystaSense Sapphire (Formula #HC/HS/43) Tub and Tile Cleaner (Formula #1115)


SpraySept14
To see the actual publication please follow the link above